Please follow these steps for network connection:
1. Connect to the Data Logger's AP network:
Locate the Data Logger network by opening WLAN on your phone or computer and searching for "AP_". xxxxxxxx" (where xxxxxxx is the Data Logger serial number).
Connect:
Select and connect to the Data Logger network. The password can be found on the Data Logger.
2. Access Configuration Page:
Open a web browser: After connecting to the Data Logger's AP network, open a web browser on your phone or computer.
Enter IP Address: In the browser's address bar, enter “10.10.100.254”.
Log In: Enter the username and password “admin”.
3. Run Setup Wizard:
Navigate to Setup Wizard: Locate the “Quick Setup” or “Setup Wizard” option.
Scan Network: The wizard will scan for available Wi-Fi networks.
Select Network: Choose the desired Wi-Fi network from the list.
Enter Password: Enter the password for the Wi-Fi network.
Enable Auto IP: Select 'Enable' to automatically obtain an IP address.
Click 'Next' and 'OK': Follow the prompts to click 'Next', then click 'OK'.
Restart: The Data Logger will restart, and you should be able to connect to the Wi-Fi network.
4. Verify Connection:
Re-login: After restarting, re-login to the configuration page (10.10.100.254).
Check if an IP address has been obtained, if the signal strength is greater than 15, and if the server is connectable. If an IP address cannot be obtained, please try configuring again.