In a master-slave inverter system, why doesn't the platform display the power output of the slave inverter?

• Related Articles

• How can I ensure that data is calculated as the sum of both inverters in master-slave inverter mode, rather than just the master inverter?

  You must switch the data source to manual mode to calculate the sum of both inverters. In smart mode, only the master inverter's data is used.

• P1 Meter Reader Troubleshooting FAQ

  Q1: What are the common causes of network configuration failure? A1: Please check the following points: WiFi frequency: Device supports 2.4GHz WiFi. (5GHz is not supported.) WiFi password: Password should be correct. WiFi signal : Signal should be ...

• Flow Chart Display Issues【SOLARMAN Smart and Business】

  Overall Troubleshooting Approach 1. Verify data source accuracy 2. Confirm correct plant type selection 3. Ensure equipment is online 4. Check if the following scenarios resolve the issue 5. If all checks pass and scenarios fail to resolve, contact ...

• FAQ for Three-Phase Smart Meters

  Q：What causes a three-phase smart meter to trigger an alarm for “current loss” and “phase overcurrent”? A： 1. The product’s logic: When the current in any phase of a three-phase system is less than 1A, the platform will not display it and show it as ...

• P1 Meter Reader Connection and Use FAQ

  Q1: How can I determine if my meter is compatible? A1: There are two ways to determine: Method 1: Check if the meter has a "P1/RJ12" interface. Method 2: Check the table below: https://www.solarmanpv.com/is-my-smart-meter-compatible Q2: What are the ...