If the connection drops due to poor signal, how long does it take to reconnect?
Check when the data logger last connected to the signal, or try manually reinstalling the data logger. Normally, the data logger automatically restarts every 3 hours; as long as the network connection is good, it will proactively reconnect immediately without any delay.
Related Articles
P1 Meter Reader Troubleshooting FAQ
Q1: What are the common causes of network configuration failure? A1: Please check the following points: WiFi frequency: Device supports 2.4GHz WiFi. (5GHz is not supported.) WiFi password: Password should be correct. WiFi signal : Signal should be ...
P1 Meter Reader Connection and Use FAQ
Q1: How can I determine if my meter is compatible? A1: There are two ways to determine: Method 1: Check if the meter has a "P1/RJ12" interface. Method 2: Check the table below: https://www.solarmanpv.com/is-my-smart-meter-compatible Q2: What are the ...
P1 Meter Reader Basic Information FAQ
Q1: Which scenarios does P1 Meter Reader (P1-2W) suit? A1: P1 Meter Reader is suitable for various household and personal energy consumption scenarios, such as: Home energy monitoring: View your home's real-time power consumption and electricity ...
I have changed my home WiFi password and need to reconnect. How do I do this?【SOLARMAN Smart】
Please follow these steps for network connection: 1. Connect to the Data Logger's AP network: Locate the Data Logger network by opening WLAN on your phone or computer and searching for "AP_". xxxxxxxx" (where xxxxxxx is the Data Logger serial ...
Solutions for Error Codes During Device Network Configuration
Scenario 1: Error Code -1000 During Device Network Configuration Cause: Bluetooth not authorized, disabled, or unsupported Solution: Enable Bluetooth authorization for the SOLARMAN app in your phone's settings Scenario 2: Error Code -1001 During ...