How can I ensure that data is calculated as the sum of both inverters in master-slave inverter mode, rather than just the master inverter?

You must switch the data source to manual mode to calculate the sum of both inverters. In smart mode, only the master inverter's data is used.   

• Related Articles

• In a master-slave inverter system, why doesn't the platform display the power output of the slave inverter?

  The platform's rule is that it only displays the master inverter. In a master-slave inverter configuration, there must be exactly one master inverter.

• Why date logger and inverter online but no plant data processing?【SOLARMAN Smart Web】

  Issue: The data logger and inverter are online normally, the data source settings are correct, but there is no data for the plant. Cause: This is due to both inverters under the plant being set as master, which prevents the platform from calculating ...

• P1 Meter Reader Troubleshooting FAQ

  Q1: What are the common causes of network configuration failure? A1: Please check the following points: WiFi frequency: Device supports 2.4GHz WiFi. (5GHz is not supported.) WiFi password: Password should be correct. WiFi signal : Signal should be ...

• LS4G-6-G Data Logger After-Sales Troubleshooting SOP

  Scenario 1: Device Offline in 4G Mode 1. Check Hardware Connections 1.1 Ensure the 4G antenna is installed and securely fastened. 1.2 Open the SIM card slot to make sure the card is inserted in the correct direction with good contact. 2. Check SIM ...

• Offline Inverter Handling Solution【SOLARMAN Business】

  Scene 1: No inverter data displayed on the platform under anti-reverse flow protection, or partial inverter offline Fault Description: Communication anomaly between platform server and inverters Causes: Incorrect inverter address Incompatible ...